6 replies to this topic

[Dorian]

hey,
are there any linux users here?
I downloaded the lastest linux build but it won't run
here's what I get :




I'm running the lastest kubuntu release with kde 3.5
I remember I could launch a past zc build under puppy linux,
why not under kubuntu?

[Alestance]

what version are you using? It runs fine on Hardy.

[Deviance]

Make sure you have allegro installed.

[Eurysilas]

I have no clue what command "sh zelda-l" is, but I usually run the binary by typing "./zelda-l", which should get you going. Other than that, I have no clue...Perhaps you can try seeing if "execute" is set in properties?

[Dorian]

what version are you using? It runs fine on Hardy.

kubuntu 8.04 "hardy heron"
Linux dorian-mende 2.6.24-16-generic #1 SMP Thu Apr 10 13:23:42 UTC 2008 i686 GNU/Linux
kde 3.5.9

Make sure you have allegro installed.

oh, I didn't do that
I tried to install liballegro4.2 with adept manager
but I have the same results with it
what did you installed exactly?

I have no clue what command "sh zelda-l" is, but I usually run the binary by typing "./zelda-l", which should get you going. Other than that, I have no clue...Perhaps you can try seeing if "execute" is set in properties?

well, I always do that to run executables files
exemple :


./zelda-l asks me to be root
and when I am, it says "command not found"

EDIT:
however the ./zelda-l command works well on puppy linux...

Edited by Dorian, 02 May 2008 - 04:13 AM.

[Saffith]

The permissions are set incorrectly after it's extracted. chmod o+x *-l should fix it.

[Dorian]

That worked! Thanks a lot Saffith
runs wells in fullscreen too



yay to linux !