13 replies to this topic

[devonodev]

I'm new to Zquest and this is my first quest. I use the door combos and and all my doors work. but I cant walk through the right door on any screen. the left, up and down doors work fine.[b]

PROBLEM SOVED!!!
i guess

Edited by devonodev, 07 June 2007 - 01:07 AM.

[Joe123]

Are you using a Dungeon or Cave type Dmap? If so, the room you're trying to walk to is probably off the edge of the Dmap. Go to Quest->Dmaps, find the Dmaps used for this area, and make sure that all the screens you are using can be seen on the screen, by moving the slider. (You may have to change some warps)

Edited by Joe123, 03 June 2007 - 03:17 AM.

[devonodev]

i have done all that but it still wont work

PLZ HELP

[Sacred Nym]

Make sure the DMap is a Dungeon and it's Level number is not 0

[Akkabus]

Make sure the middle combo for the right door is walkable on the bottom half.

[devonodev]

Make sure the middle combo for the right door is walkable on the bottom half.

i dont understand

[EnnonFenom]

here is a few things that should help!
ok in this shoot you will see that the dmap type is dungeon
http://i165.photobuc...ndmapeditor.png

And the level number is higher than zero, because zero is for your over world!

And what Akkabus, ment was make sure the combo is at lest part way walkable! Look at this pick and you will see what Akkabus ment!
http://i165.photobuc...m/DOORCOMBO.png

[devonodev]

i have just realised that no matter what tile i use. I cant move right.

[EnnonFenom]

i have just realised that no matter what tile i use. I cant move right.

what do you mean? HUM well all I can think of is maybe you post a link to your quest the some can figure out what is going wrong!
By the way what zc/zq version are you using?

[devonodev]

I will have my quest uploaded soon. I am using v2.10

[Dawnlight]

For the right door, make sure the top half of the tile is not walkable and the bottom half walkable. You can tell be pressing "W" to find all the walkable areas

[Mitchfork]

You're not manually putting the tiles in, right? Are you clicking Tools -> Doors? That SHOULD work...

[devonodev]

problem solved! well not exactly.
I deleted my dungeon and started again, and my new dungeon works perfectly.

Thx for all u guys that tried to help!

[EnnonFenom]

one last reminder, for dungeons on a dungeon dmap you have 8 screens straight across 0-7 and the same straight down 0-7
if you have a door on lets say 7,7 the door on the bottom wont work neither will the doors on the right, so if you on any edge don't put a door facing that edge or screens beyond any of the 7th row. and make sure to use tools>doors, select door type and style, the the side you want it on, and you should not have a problem