Jump to content


Multilayer Combos

  • Please log in to reply
2 replies to this topic

#1 Mlvluu



  • Members

Posted 16 August 2018 - 02:50 PM

How do I make a part of a combo be in a different layer than the other?


#2 Saffith


    IPv7 user

  • ZC Developers
  • Gender:Male

Posted 16 August 2018 - 03:11 PM

A single combo can only really be on one layer, although a combo with the "Overhead" type will sort of do that. Any pixels of color 0 will be on layer 0, and other colors will be drawn on a higher layer.

If you want more than that, you can set up a combo alias. Switch to alias mode (click the button labeled "Normal" to the left of the combo table three times, or else press O three times) and right-click a blank spot to open the editor. Click "Properties" and enable the layers you want to use, and then you can set a combo for each layer.

#3 klop422


    Evil Crazy Mastermind

  • Members
  • Real Name:Not George
  • Gender:Male
  • Location:Planet Earth

Posted 16 August 2018 - 03:20 PM

How do you mean 'part' of it?

There's no way to do this. You can make two combos, one of which has some of the attributes, and one of which has the others. If you want the 'ground' portion of a combo to be walkable and the 'floating' portion (like a pillar or a treetop) be above Link (which is what I'm assuming you want to use it for, though you might be wanting to do something else), then you need to have two combos, one of which is the ground portion (can be literally anything), and one of which is the portion that should be layered over Link and nothing else. Make sure that you use the transparent 'colour' and blacks in the right places when using those tiles.


If not, what are you trying to do? It's normally useful to give that information when asking for help, since there might be a much simpler way of going about what you're trying to achieve.


EDIT: Ninja'd for the first time in a while. What I say is still valid, though, I think, just a little redundant.

Edited by klop422, 16 August 2018 - 03:21 PM.

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users